Cirris test modules

modules and adapters

Tile module		These modules would be used on a touch table. They are automatic module so when the cable has passed the connector would be automatically released. The interface wiring would be housed below the modules.
Block modules		These modules would be used on an easy-wire test table. They have manual release.
Push-back module		This is an example of a push-back module. The connector under test is inserted into the module, if continuity passes OK then the rear part would move forward trying to push the pins out of the connector. Any that were not latched would cause a failure of the test. This is a fully automatic module so when the cable has passed the connector would be automatically released.

Cirris Test Table
	This is an example of a small harness test table. Each 100mm square tile can be customised with connectors, indicators, switches, etc. all wired back to an internal test interface that is accessed at the rear. Connector modules can include gold sprung probes, pushback probes, pneumatic release mechanisms and seal tests to ensure maximum test coverage with highest throughput and productivity.